94-97 Honda Accord Blinker Indicator Guide

BLINKER INDICATOR INSTALL GUIDE
94-97 Honda Accord

This install guide is intended for use by LEDautomotive.com customers and winners of eBay auctions by entcee. We cannot guarantee a successful LED conversion with items not purchased from us.

*Please read this all the way through before doing this install!*

We will not be held responsible for any mistakes, problems, or damage done to any part of your car. Follow this install guide carefully, and you should have no problems. If you are unsure about ANYTHING, please email us. We will help you out to the best of our ability.

Here Is What You Will Need:

- Phillips head screw driver
- Flat head screw driver

Let's Get Started

Follow the steps in the Gauge Cluster Install Guide [Here] to remove the gauge cluster.

To remove the white plastic cover from the back of the gauge cluster, remove the two screws holding it on. (Red circles in the picture below.) Also remove the bulb that has the wires coming out of it. (Blue arrow in the picture below.)

Now remove the 13 screws holding down the circuit board. Be careful not to move the gauge cluster around to much after removing the screws, they hold the gauges in place. Set the circuit board to the side.

Now you can see the bulb holders for the indicators. (Blinkers, check engine, SRS, high beams, seat belt, and e-brake.) Just remove the bulbs for the blinker indicators and install the wedge LEDs.

Reassemble the gauge cluster. Before putting everything back together, you have to test the indicators. Plug the wire harnesses back in the cluster and make sure the dimmer button is also plugged in other wise no interior lights will turn on. See which indicators do not light up. For the ones that do not light up, just take the wedge LED out and turn it 180 degrees and try again. Once all the lights light up, reassemble everything in reverse order.

If you have any questions, feel free to email me at Nate@LEDautomotive.com.