|
GAUGE CLUSTER LED INSTALL GUIDE
99-03 Acura TL & 01-03 Acura CL
This install guide is intended for use by LEDautomotive.com customers and winners of eBay auctions by entcee. We cannot guarantee a successful LED conversion with items not purchased from us. |
*Please
read this all the way through before doing this install!*
We
will not be held responsible for any mistakes, problems, or damage
done to any part of your car. Follow this install guide carefully,
and you should have no problems. If you are unsure about ANYTHING,
please email us. We will
help you out to the best of our ability. |
Here Is What You Will Need:
|
- Phillips Screwdriver
-
Flathead screwdriver
-
Small needle nose pliers
-
Upholstery Fastener Remover (Optional)
|
Follow the steps in the Climate Control Install Guide [Here] to remove the trim panel.
To remove the gauge cluster, remove the 4 Phillips screws shown in the pictures
Remove the 3 harness connectors on the top of the gauge cluster.
Remove the blue bulb holders for the bulbs that light up the gauge faces and remove the bulb from the blue bulb holder. Use a Kleenex as your fingers could be too slippery to remove them. Don’t use pliers as you’you will end up breaking them and making a mess. Istall the LED into the bulb holder and insert the assembly back into the gauge cluster..
Connect the wire harnesses and test the LEDs. If any of them do not light up you will have to take them out and turn them around 180 degrees. (you can rotate the entire LED/blue bulb holder assembly). Once all the LEDs are lighting up, re-install the gauge cluster and re-install the panel.
|
|
If you have any questions, feel free to email me at Nate@LEDautomotive.com.
|
